How to clean the water pump of a pet water dispenser?
1. Remove the water pump from the water dispenser
2. Remove the water flow regulating valve on the side of the water pump
3. Remove the plastic filter screen from the water pump
4. Remove the inner baffle of the water pump
5. Pull out the water pump motor shaft. After pulling out the water pump shaft, first clean the shaft and the groove after pulling out the shaft. Pay attention to whether there is pet hair in the groove!
After completing the above steps, you can start cleaning!!
Article source: Pet water dispenser pump http://www.zsboyang.com
-
06-01
Reasons for high temperature of DC brushless water pump
The power supply voltage is high, exceeding the additional voltage of the motor by more than 10%, causing an increase in motor iron loss and causing the motor to heat up. DC brushless water pumpIf the
-
05-12
DC brushless water pump: The advantage of brushless DC pump replacing AC pump
In recent years, DC pumps have become well-known among many companies due to their small size, low power, and high safety factor. Engineers will consider upgrading the original communication pump to a
-
04-02
DC booster pump: How to choose a water heater booster pump
The booster pump of a water heater is an important accessory in a water heater, and its quality directly affects the quality, brand, and reputation of the water heater. Therefore, when selecting a boo
-
02-14
DC booster pump: a key task in DC pump management
From the fundamental perspective of handling demands, manufacturers of DC water pumps pursue input-output, which means pursuing the efficiency of DC water pump adoption and operation. From this perspe